D-Link DSL-2542B Spécifications télécharger pdf (Page 36)

Section 3 – Configuration

D-Link DSL-2542B User Manual

Outbound Filter

To access the Outbound FIlter window, click the Outbound Filter button in the Advanced directory.

The Outbound Filter allows you to create a filter rule to block outgoing IP

traffic by specifying a filter name and at least one condition on this

window. All of the specified conditions in this filter rule must be satisfied

for the rule to take effect. Filters are used to allow or deny LAN or WAN

users from accessing the Internet or your internal network.

Click the Add/Apply button and then click the Reboot button on the left

panel to let your changes take effect.

Filters Parameter Description

Name

Enter a name for the new filter.

Protocol

Select the transport protocol (TCP, UDP, ICMP, TCP/

UD, or Any) that will be used for the filter rule.

Source IP Address & Source

Subnet Mask

For an Outbound Filter, this is the IP address or IP

addresses and their associated subnets on your LAN

for which you are creating the filter rule. For an

Inbound Filter, this is the IP address or IP addresses

and their associated subnets for which you are

creating the filter rule.

Source Port

The Source Port is the TCP/UDP port on either the

LAN or WAN depending on if you are configuring an

Outbound or Inbound Filter rule.

Destination IP Address &

Destination Subnet Mask

Where the Destination IP address and subnet mask

resides also depends on if you are configuring an

Inbound or Outbound filter rule.

Destination Port

The Destination Port is the TCP/UDP port on either

the LAN or WAN depending on if you are configuring

an Outbound or Inbound Filter rule.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 58 59

Pas de commentaire

D-Link DSL-2542B Spécifications Page 36