D-Link DPH-400S Guide d'installation télécharger pdf (Page 10)

1.6 LED introduction

Table 1 Programmable key LEDs for BLF

LED Status Description

Steady green The object is in idle status.

Slow blinking red The object is ringing.

Steady red The object is active.

Fast blinking red The object is failed.

Off No subscribe.

Table 2 Programmable key LEDs for Presence

LED Status Description

Steady green The object is online.

Slow blinking red The object is ringing.

Steady red The object is active.

Fast blinking red The object is failed.

Off No subscribe.

Table 3 Power Indication LED

LED Status Description

Steady red Power on.

Fast Blinking red There is an incoming call.

Off Power off.

2 Initial connecting and Setting

2.1 Connect the phone

2.1.1 Connect to network

Step 1: Connect the IP Phone to the corporate IP telephony network. Before you

connect the phone to the network, please check if your network can work

normally.

You can do this in one of two ways, depending on how your workspace is set up.

Direct network connection—by this method, you need at least one available

Ethernet port in your workspace. Use the Ethernet cable in the package to

connect WAN port on the back of your phone to the Ethernet port in your

workspace. Since this VoIP Phone has router functionality, whether you have a

broadband router or not, you can make direct network connect. The following

two figures are for your reference.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 92 93

Pas de commentaire

D-Link DPH-400S Guide d'installation Page 10