DES-1005D 5-port 10/100Mbps Dual Speed Ethernet Switch User’s Guide Rev. 02 (OCT. 1999) 6012-9830016 Printed In Taiwan RECYCLABLE
1 INTRODUCTION This chapter describes the features of the Switch and some background information about Ethernet/Fast Ethernet switching technology. F
2 Switching Technology Another approach to pushing beyond the limits of Ethernet technology is the development of switching technology. A switch bri
3 Switching LAN technology is a marked improvement over the previous generation of network bridges, which were characterized by higher latencies. To
4 allocated for each port, while controlling the data flow between the transmit and receive nodes to guarantee against all possible packet loss. The
5 UNPACKING AND SETUP This chapter provides unpacking and setup information for DSS-5+. Unpacking Open the shipping cartons of the Switch and careful
7 IDENTIFYING EXTERNAL COMPONENTS This section identifies all the major external components of the DSS-5+. Both the front and rear panels are shown f
8 it on. MDI-X Jacks: Use these jacks to connect stations to the hub. These are MDI-X (Medium-Dependent Interface, Cross-wired) jacks, which mean, y
9 green as Fast Ethernet data is transmitted or received. The indicator lights amber when the port is connected to a 10Mbps Ethernet station or othe
FCC Certifications This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC R
9 CONNECTING THE SWITCH This chapter describes how to connect the DSS-5+ to your Fast Ethernet network. PC to Switch A PC can be connected to the S
10 Hub to Switch A hub (10 or 100BASE-TX) can be connected to the Switch via a two-pair Category 3, 4, or 5 UTP/STP straight cable. For 100Mbps oper
11 B. Using crossover cable When using crossover cable, the connection can be made from any ports of the Switch to any port of the Hub. Switch to Swi
12 Port Speed & Duplex Mode After plugging the selected cable to a specific port, the system uses auto-negotiation to determine the transmission
13 TECHNICAL SPECIFICATIONS General Standards IEEE 802.3 10Base-T Ethernet IEEE 802.3u 100 Base-TX Fast Ethernet ANSI/IEEE Std 802.3 NWay auto-negot
14 Physical and Environmental DC inputs DC5V/2.4A Power Consumption 10 watts. (max.) Temperature Operating: 0° ~ 50° C Storage: -10° ~ 70° C Humidi
15 RJ-45 PIN SPECIFICATION When connecting your 5-port 10/100Mbps Dual Speed Ethernet Switch to another switch, a bridge or a hub, a modified crossov
16 The standard RJ-45 receptacle/connector The following shows straight cable and crossover cable connection: Straight cable for Switch (uplink M
LIMITED WARRANTY D-Link Systems, Inc. (“D-Link”) provides this limited warranty for its product only to the person or entity who originally purchase
determines in its sole discretion that it is not practical to repair or replace the defective Hardware, the price paid by the original purchaser for
Submitting A Claim. Any claim under this limited warranty must be submitted in writing before the end of the Warranty Period to an Authorized D-Lin
IS” WITHOUT ANY WARRANTY OF ANY KIND INCLUDING, WITHOUT LIMITATION, ANY WARRANTY OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE AND NON-INFRIN
i TABLE OF CONTENTS ABOUT THIS GUIDE...III PURPOSE... III TERMS
ii HUB WITHOUT UPLINK (MDI-II) PORT ...10 A. Using straight cable .....
iii ABOUT THIS GUIDE Congratulations on your purchase of the DSS-5+ 5-port 10/100Mbps Dual Speed Ethernet Switch. This device integrates 100Mbps Fast
Commentaires sur ces manuels