DGS-1008TL 8-Port 10/100/1000Mbps Gigabit Ethernet Switch Manual RECYCLABLE Rev.1.20 29071600GS08010
8 The Switch uses strict priority for Scheduling. Strict priority-based scheduling, any packets residing in the higher priority queues are transmitte
9 Setup The setup of the Switch can be performed using the following steps: The surface must support at least 5 kg (11.02 lbs). The power outl
10 Rack Installation The Switch can be mounted in an EIA standard size, 19-inch rack, which can be placed in a wiring closet with other equipment. T
11 IDENTIFYING EXTERNAL COMPONENTS This chapter describes the front panel, rear panel and LED indicators of the Switch Front Panel Front panel v
12 The Switch LED indicators Per unit: Power: A steady green light indicates the switch is power on. Per port: Link/Act: A steady green light
13 Rear Panel The rear panel of the Switch AC Power Connector This is a three-pronged connector that supports the power cord. Supported input
14 TECHNICAL SPECIFICATIONS General Standards: IEEE 802.3 10BASE-T IEEE 802.3u 100BASE-TX IEEE 802.3ab 1000BASE-T Protocol: CSMA/CD Data Transfer R
15 Physical and Environmental AC inputs: 100 – 240 VAC Universal, 50/60 Hz Power Consumption: 10.3 watts maximum Operating Temperature: 0° ~ 40°C (
TABLE OF CONTENTS ABOUT THIS MANUAL ... 1 TERMS
1 ABOUT THIS MANUAL This manual will tell you how to install your D-Link DGS-1008TL 8-Port 10/100/1000Mbps Gigabit Ethernet Switch, and how to connec
2 INTRODUCTION This section describes the features of the DGS-1008TL 8-Port 10/100/1000Mbps Gigabit Ethernet Switch, as well as giving some backgroun
3 Switching Technology Switching is a cost-effective way of increasing the total network capacity available to users on a LAN. If an Ethernet network
4 For Ethernet networks, a switch is an effective way of eliminating the problem of chaining hubs beyond the “two-repeater limit.” A switch can be us
5 Features The DGS-1008TL 8-Port 10/100/1000Mbps Gigabit Ethernet Switch was designed for easy installation and high performance in an environment wh
6 IEEE802.1P AND QOS The DGS-1008TL Switches support 802.1p priority queuing Quality of Service. The implementation of QoS (Quality of Service) and b
7 Mapping QoS on the Switch The picture above shows the default priority setting for the Switch. Class-1 has the higher priority than Class-0 on the
Commentaires sur ces manuels