D-Link DCS-5010L Manuel d'utilisateur télécharger pdf (Page 17)

17D-Link DCS-5010L User Manual

Section 2 - Installation

To create a WPS connection:

Step 1

Make sure the camera is plugged in, then press and hold the WPS button for

ten seconds. The blue WPS status LED will start blinking.

Step 2

Press the WPS button on your router within 60 seconds. The WPS button is

usually on the front or side of your router. On some routers, you may need

to log in to the web interface and click on an on-screen button to activate

the WPS feature. If you are not sure where the WPS button is on your router,

please refer to your router’s User Manual.

The DCS-5010L will automatically create a secure wireless connection to your

router. While connecting, the blue LED will ash and your camera will reboot.

WPS - Push Button Setup

WPS Button

If your router supports Wi-Fi Protected Setup (WPS), you can create a secure wireless connection using the WPS Button on the

back of the camera. Please note that WPS setup only establishes a secure wireless connection, and you will still need to run

the Setup Wizard to congure your camera.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 47 48

Pas de commentaire

D-Link DCS-5010L Manuel d'utilisateur Page 17