D-Link DWL-2600AP Manuel d'utilisateur télécharger pdf (Page 64)

Unied Access Point Administrator’s Guide

Page 64

March 2012

Section 4 - Managing the Access Point

Creating a Management Access Control List (ACL)

You can create an access control list (ACL) that lists up to ve IPv4 hosts and ve IPv6 hosts that are authorized to

access the AP management interface. If this feature is disabled, anyone can access the management interface from

any network client by supplying the correct AP username and password.

To create an access list, click the Management ACL tab.

Figure 32 - Congure Management Access Control Parameters

Field Description

Management ACL

Mode

Enable or disable the management ACL feature. At least one IPv4 address should be

congured before enabling Management ACL Mode. If enabled, only the IP addresses you

specify will have Web, Telnet, SSH, and SNMP access to the management interface.

IP Address (1–5) Enter up to ve IPv4 addresses that are allowed management access to the AP. Use

dotted-decimal format (for example, 192.168.10.10).

IPv6 Address (1–5) Enter up to ve IPv6 addresses that are allowed management access to the AP. Use the

standard IPv6 address format (for example 2001:0db8:1234::abcd).

Table 35 - Management ACL

Note: After you congure the settings, click Apply to apply the changes and to save the settings.

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 127 128

Pas de commentaire

D-Link DWL-2600AP Manuel d'utilisateur Page 64