D-Link DSL-500T Manuel d'utilisateur télécharger pdf (Page 35)

DSL-500T ADSL Router User’s Guide

Configure Connection 1 for Static IP for WAN

Static is used whenever a known static IP is assigned. The accompanying information such as the Subnet mask

and the gateway should also be specified in order to be able to connect. Up to three Domain Name Server (DNS)

addresses can also be specified. These are the servers would enable you to have access to other web servers.

Valid IP addresses range from 1.0.0.1 to 253.255.255.254.

Figure 3-8. Setup – Configure Connection 1 for Static IP for the WAN

To configure the WAN connection for Static, perform the steps listed below. Some of the settings do not need to

be changed the first time the device is set up, but can be changed later if you choose.

1. Click the Connection 1 button under WAN Setup to view the default PPPoA Connection Setup

configuration menu.

2. Select Static from the Type: pull-down menu. This action will change the menu so it offers different

settings for configuration.

3. Type in a Name: in the space provided (conn_1_Static_8_35 is used in the above example).

4. If you are told to change the VPI or VCI values, type in the values given to you by your service

provider. Many users will be able to use the default settings.

5. Leave the default QoS values if you are unsure or the ISP did not provide this information.

6. Do not change the PCR or SCR values unless you are required to do so. If you are told to change these,

type in the values given to you by your service provider.

7. The Encapsulation values LLC (SNAP) and VC (MUX) are two different methods of encapsulating

the PPP packet. Contact your ISP to make sure which encapsulation is being supported.

8. Based on the information provided by your ISP, enter the IP Address, Subnet Mask, Default Gateway

(if provided), and Domain Name Services (DNS) values (if provided).

9. Select the desired Mode, Bridged or Routed.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 86 87

Pas de commentaire

D-Link DSL-500T Manuel d'utilisateur Page 35