D-Link DSL-302G Guide de l'utilisateur télécharger pdf (Page 66)

DSL-302G ADSL Modem User’s Guide

 Your ISP uses protocols that require bridging with your LAN. The device can be configured to appear

as a bridge when communicating with your ISP, while continuing to provide Modem functionality for

your LAN.

 Your LAN may include computers that communicate using "layer-3" protocols other than the Internet

Protocol. These include IPX® and AppleTalk®. In this case, the device can be configured to act as a

bridge for packets that use these protocols while continuing to serve as a Modem for IP data.

Bridging Configuration

To add or change bridge configuration settings, log into the Configuration Manager and click on the Bridging

button in the Bridging folder.

Bridge Configuration Menu

To define Bridge settings for a new virtual connection, click the Add button. To delete an existing setting, click

the trashcan (

) for that set.

To enable bridging, you simply specify the device interfaces on which you want to bridge data, and then enable

bridging mode by clicking the Enable option.

Click the Submit button to save the settings in temporary memory. When you are done making changes to the

configuration settings, open the Commit & Reboot menu and click the Commit button to save your changes to

permanent memory.

Note

If you enable bridging on an interface that has already been assigned an IP

address, then it is considered IP-enabled and will route (rather than bridge) IP

packets received on the interface. The interface will bridge non-IP data it

receives, however.

You can determine whether the Ethernet (eth-0) and USB (usb-0) interfaces

have been assigned IP addresses by displaying the IP Address Table (display

the Routing tab, then click IP Addr). These interfaces will display in the table

only if they have been assigned IP addresses.

You can check whether the eoa-0 interface has been assigned an IP address

by displaying the EOA configuration table (display the WAN tab, and then click

EOA). If the Config IP Address field is empty and the Use DHCP field contains

the word Disable, then no IP address has been assigned.

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 98 99

Pas de commentaire

D-Link DSL-302G Guide de l'utilisateur Page 66