D-Link 3100 24 - DGS Switch - Stackable Guide d'installation télécharger pdf (Page 36)

DGS-3100 Series Gigabit Stackable Managed Switch Hardware Installation Guide

Connecting the Device in a Stack

The device can operate as member of a stack. The two HDMI stacking ports on the back of the device are used for full-

duplex stacking between units, and each port supports 5Gbps full-duplex traffic.

There are two stacking topologies supported by the device, the Ring topology or Chain topology.

Figure 3-6. Connecting the Device in a Stack

The device is “Plug and Play” in terms of stacking connection and configuration. Before powering up the device, connect

the devices into the required stacking topology. The Stacking Master and slave designations are configured through

automatic discovery. Manually changing the stacking configuration is through switch’s web page and CLI commands, and

once the device has been booted and is operational.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 73 74

Pas de commentaire

D-Link 3100 24 - DGS Switch - Stackable Guide d'installation Page 36