D-Link DGS-1210-16 Manuel d'utilisateur télécharger pdf (Page 35)

5 Configuration D-Link Web Smart Switch User Manual

Note: Trap Name must be selected from a

Community Name

System > Password Access Control

Setting a password is a critical tool for managers to secure the Web-Smart Switch. After entering the old

password and the new password twice, click Apply for the changes to take effect.

Figure 49 – System > Password Access Control

System > System Log Settings

System Logs record and manage events, as well as report errors and informational messages. Message

severity determines a set of event messages that will be sent. Click Enable so you can start to configure the

related settings of the remote system log server, then press Apply for the changes to take effect.

Figure 50 – System > System Log Settings

Server IP Address: Specifies the IP address of the system log server.

UDP Port: Specifies the UDP port to which the server logs are sent. The possible range is 1 – 65535, and

the default value is 514.

Time Stamp: Select Enable to time stamp log messages.

Severity: Specifies the minimum severity from which warning messages are sent to the server. There are

three levels. When a severity level is selected, all severity level choices above the selection are selected

automatically. The possible levels are:

Warning - The lowest level of a device warning. The device is functioning, but an operational

problem has occurred.

Informational - Provides device information.

All - Displays all levels of system logs.

Facility: Specifies an application from which system logs are sent to the remote server. Only one facility can

be assigned to a single server. If a second facility level is assigned, the first facility is overwritten. There are

up to eight facilities can be assigned (Local 0 ~ Local 7),

Configuration > Jumbo Frame

D-Link Gigabit Web Smart Switches support jumbo frames (frames larger than the Ethernet frame size of

1536 bytes) of up to 10,000 bytes (tagged). Default is disabled, Select Enabled then click Apply to turn on

the jumbo frame support.

Figure 51 – Configuration > Jumbo Frame

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 70 71

Pas de commentaire

D-Link DGS-1210-16 Manuel d'utilisateur Page 35