D-Link DGS-1210-16 Manuel d'utilisateur télécharger pdf (Page 51)

5 Configuration D-Link Web Smart Switch User Manual

Figure 78 – QoS > DSCP Priority Settings

Select QoS Mode: D-Link Smart Switch allows the user to prioritize the traffic based on the 802.1p priority in

the VLAN tag or the DSCP (Differentiated Services Code Point) priority in the IP header. Only one

mechanism is selected to prioritize the packets at a time.

Queuing Mechanism: Select Strict Priority to process the packets with the highest priority first. Select WRR

(Weighted Round-Robin) to process packets according to the weight of each priority. When a priority level

has reached its egress weight, the system will process the packets in the next level even if there are

remaining packets. D-Link Smart Switch system’s weight of priority levels are: 8 (Highest), 4 (High), 2

(Medium) and 1 (Low) packet. By default, the queuing mechanism is Strict Priority.

Default Priority: Default is Medium. In 802.1p QoS mode, you can use From Port / To Port to specify the

default priority of each port. In DSCP mode, you can configure the global default priority value by using From

DSCP value / To DSCP value.

Security > Trusted Host

Use Trusted Host function to manage the switch from a remote station. You can enter up to ten designated

management stations networks by defining the IP address/Subnet Mask as seen in the figure below.

Figure 79 Security > Trusted Host

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 70 71

Pas de commentaire

D-Link DGS-1210-16 Manuel d'utilisateur Page 51