D-Link DP 300 - Print Server - Parallel Manuel d'utilisateur télécharger pdf (Page 9)

DP-300+ Multiprotocol Fast Ethernet Print Server User’s Guide

Introduction

Port Connectors

The DP-300+’s three printer ports are located on its rear panel.

Two identical parallel ports are labeled LPT1 and LPT2; the

single serial port is labeled COM. These printer ports are

independently configurable using the PS Admin program or the

print server’s telnet interface. (See the Print Server

Administration User’s Guide for information about configuring

the print server’s ports.)

The print server also supports web configuration permitting

users to configure settings through the web browser. DP-300+

default IP address as follows:

♦ Default IP address – 192.168.0.10

♦ Subnet Mask – 255.255.255.0

Note:-

The PC’s IP address must correspond with the print server’s IP

address in the same segment for the two devices to

communicate.

Figure 1 -2 Port Connectors

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 37 38

Pas de commentaire

D-Link DP 300 - Print Server - Parallel Manuel d'utilisateur Page 9