D-Link DGS-1210-16 Manuel d'utilisateur télécharger pdf (Page 32)

5 Configuration D-Link Web Smart Switch User Manual

Figure 44 – Device Information

System > System Settings

The System Setting allows the user to configure the IP address and the basic system information of the

Switch.

IP Information: There are two ways for the switch to obtain an IP address: Static and DHCP (Dynamic Host

Configuration Protocol).

When using static mode, the IP Address, Subnet Mask and Gateway can be manually configured. When

using DHCP mode, the Switch will first look for a DHCP server to provide it with an IP address (including

network mask and default gateway) before using the default or previously entered settings. By default the IP

setting is static mode with IP address is 10.90.90.90 and subnet mask is 255.0.0.0.

System Information: By entering a System Name and System Location, the device can more easily be

recognized through the SmartConsole Utility and from other Web-Smart devices on the LAN.

no action for a specific time span in the Web-based Management. If the current session times out (expires),

the user is required a re-login before using the Web-based Management again. Selective range is from 3 to

30 minutes, and the default setting is 5 minutes.

Group Interval: The D-Link Web Smart Switch will routinely send report packets to the SmartConsole Utility

in order to maintain the information integrity. The user can adjust the Group Interval to optimal frequency.

Selective range is from 120 to 1225 seconds, and 0 means disabling the reporting function.

Figure 45 – System > System Setting

System > Trap Settings For SmartConsole

By configuring the Trap Setting, it allows SmartConsole Utility to monitor specified events on this Web-Smart

Switch. By default, Trap Setting is disabled. When the Trap Setting is enabled, enter the Destination IP

address of the managing station that will receive trap information.

Figure 46 – System > Trap Setting

You can select which event message(s) will be sent to the managing station

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 70 71

Pas de commentaire

D-Link DGS-1210-16 Manuel d'utilisateur Page 32