D-Link DES-3225G Manuel d'utilisateur Page 94
- Page / 219
- Table des matières
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
24-port NWay Ethernet Switch User’s Guide
80 Using the Console Interface
Parameters allow you to change the behind the scene
parameters of the Spanning Tree Algorithm at the bridge
level. The parameters for this section have been fully
explained in Chapter 5’s Switch Management, see STA
Operation Levels: On the Bridge level, and User-Changeable
Parameters. It is recommended that you read these
sections, as well as the introductory section in the same
chapter entitled Spanning Tree Algorithm before changing
any of the parameters.
STP Parameter Settings
To change the Protocol Parameters:
1.
Choose Configure Spanning Tree Protocol from the
Configuration menu. The following Configure
Spanning Tree Protocol menu will be displayed:
Figure 6-16. Configure Spanning Tree Protocol menu
2.
Choose STP Parameters Setting to access the
following screen:
- DES-3225G 1
- DES-3225GF 1
- 24-Port Fast Ethernet 1
- User’s Guide 1
- Wichtige Sicherheitshinweise 2
- Limited Warranty 4
- Software: 5
- Trademarks 7
- Copyright Statement 7
- FCC Warning 7
- CE Mark Warning 7
- VCCI Warning 8
- BSMI Warning 8
- Overview of this User’s Guide 13
- About This Guide 14
- NTRODUCTION 15
- Gigabit Ethernet Technolog 16
- Switching Technolog 17
- Features 18
- Performance features 19
- NPACKING AND 21
- Installation 22
- Rack Installation 23
- Power on 24
- Power Failure 25
- DENTIFYING 26
- OMPONENTS 26
- Rear Panel 27
- Side Panels 28
- Optional Plug-in Modules 29
- 100BASE-FX Fiber Module 30
- 1000BASE-SX Gigabit Module 31
- LED Indicators 32
- ONNECTING 34
- Switch to Hub or Switch 35
- 22 Connecting The Switch 36
- 10BASE-T Device 37
- 100BASE-TX Device 37
- Switch Management Concepts 39
- IP Addresses and SNMP 40
- Community Names 40
- 28 Switch Management Concepts 42
- Packet Forwarding 44
- Filtering Database 45
- Spanning Tree Algorithm 46
- On the Bridge Level 47
- On the Port Level 48
- Illustration of STA 50
- Port Trunking 52
- 40 Switch Management Concepts 54
- MAC-based VLANs 55
- Port-based VLANs 56
- VLAN Segmentation 57
- Graphics 58
- Workstations 58
- 46 Switch Management Concepts 60
- 48 Switch Management Concepts 62
- Broadcast Storms 63
- Segmenting Broadcast Domains 64
- Eliminating Broadcast Storms 64
- SING THE 66
- NTERFACE 66
- Console Usage Conventions 67
- User Accounts Management 70
- Saving Changes 71
- By Registered Users 73
- View/Delete User Accounts 75
- Setting Up The Switch 76
- Configure IP Address 77
- Configure Console 79
- Advanced Settings 82
- Configure Ports 83
- Configure Slot1 Module 87
- Configure Slot2 Module 90
- Configure Port Mirroring 92
- STP Parameter Settings 94
- STP Port Contro 98
- Using the Console Interface 101
- Configure IGMP Filtering 104
- Configure VLAN 108
- Configure MAC-Based VLA 110
- Configure Trunk 118
- System Utilities 121
- Save Settings to TFTP Server 123
- SNMP Manager Configuration 125
- Switch Monitoring 127
- Traffic Statistics 128
- Port Traffic Statistics 130
- Port Packet Error Statistics 131
- Browse Address Table 135
- Browse IGMP Status 136
- Switch History 138
- Resetting the Switch 139
- Restart System 140
- Factory Reset 140
- ANAGEMENT 142
- Getting Started 143
- Management 143
- Configure Switch 144
- IP Settings 145
- Port Settings 146
- Port Mirroring 149
- Switch Settings 150
- Advanced 152
- Configure 153
- Permanent Address Table 155
- Permanent Multicast Filtering 157
- Multicast Forwarding Table 159
- Spanning Tree 161
- IGMP Filtering 166
- Configure 802.1Q IGMP 167
- Configure VLAN Mode 169
- Configure 802.1Q VLA 172
- Configure Management 176
- User Accounts 178
- Console Port Settings 179
- Switch Overview 181
- Port Statistics 182
- Traffic in Bytes: 183
- Traffic in Frames: 183
- Other errors: 184
- Packet Analysis 186
- Utilization 188
- Reset and Update 192
- Reset to Factory Default 193
- Update Firmware 194
- Change Configuration File 195
- Upload Log File 197
- Save Changes 198
- ECHNICAL 199
- PECIFICATIONS 199
- Physical and Environmental 200
- Performance 201
- PECIFICATION 202
- RJ-45 Pin Specification 189 203
- ONFIGURATION 204
- Sample Configuration File 191 205
- 192 Sample Configuration File 206
- WITCHING 207
- OFTWARE 207
- Index 195 209
- 196 Index 210
- Index 197 211
- 198 Index 212
- Index 199 213
- 200 Index 214
- Index 201 215
- Offices 216
- U.K. D-LINK EUROPE 217
- U.S.A. D-LINK U.S.A 217
- Registration Card 218
Produits connexes et manuels pour Commutateurs de réseau D-Link DES-3225G
(15 pages)
(42 pages)© 2020, manymanuals.fr. Tous droits réservés | 2.311 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels