D-Link DWS-1008 Informations techniques télécharger pdf (Page 113)

100

101

112

DWS-1008 CLI Reference Guide

D-Link Systems, Inc.

IP Services Commands

show snmp usm

Displays information about SNMPv3 users.

Defaults: None

Access: Enabled

Examples: To display USM settings, use the following command:

DWS-1008# show snmp usm

USM users:

“nmsuser”, engineID=localSnmpID

access=read-notify

auth=NONE

encrypt=NONE

notify target use cnt=0

The table below describes the ﬁelds in this display.

Field Description

USM name Name of the SNMPv3 user.

engineID Engine ID for the USM name, which is either the local switch or the

notiﬁcation target where informs are to be sent.

access Access settings for the string:

• read-only - an SNMP management application using

the string can get (read) object values on the switch but

cannot set (write) them.

• read-notify - An SNMP management application using

the string can get object values on the switch but cannot

set them. The switch can use the string to send notiﬁcations.

• notify-only - The switch can use the string to send

notiﬁcations.

• read-write - An SNMP management application using the

string can get and set object values on the switch.

• notify-read-write - An SNMP management application using

the string can get and set object values on the switch. The

switch can use the string to send notiﬁcations.

auth Authentication type:

• md5

• sha

• none

encrypt Encryption (privacy) setting:

• des

• 3des

• aes

• none

notify target use cnt Number of times this community is speciﬁed in a notiﬁcation target

entry.

1 2 ... 108 109 110 111 112 113 114 115 116 117 118 ... 405 406

Commentaires sur ces manuels

Pas de commentaire

D-Link DWS-1008 Informations techniques Page 113

Commentaires sur ces manuels

Produits connexes et manuels pour Commutateurs de réseau D-Link DWS-1008