D-Link DWS-1008 Informations techniques télécharger pdf (Page 231)

100

101

230

DWS-1008 CLI Reference Guide

D-Link Systems, Inc.

STP Commands

Use Spanning Tree Protocol (STP) commands to conﬁgure and manage spanning trees

on the virtual LANs (VLANs) conﬁgured on a DWS-1008 switch, to maintain a loop-free

network. This chapter presents STP commands alphabetically. Use the following table to

locate commands in this chapter based on their use.

clear spantree portcost

Resets to the default value the cost of a network port or ports on paths to the STP root bridge

in all VLANs on a switch.

Syntax: clear spantree portcost port-list

port-list List of ports. The port cost is reset on the

speciﬁed ports.

Defaults: None.

Access: Enabled.

Usage: This command resets the cost in all VLANs. To reset the cost for only speciﬁc

VLANs, use the clear spantree portvlancost command.

Examples: The following command resets the STP port cost on ports 5 and 6 to the

default value:

DWS-1008# clear spantree portcost 5-6

success: change accepted.

clear spantree portpri

Resets to the default value the priority of a network port or ports for selection as part of the

path to the STP root bridge in all VLANs on a switch.

Syntax: clear spantree portpri port-list

port-list List of ports. The port priority is reset to 32 (the default) on the

speciﬁed ports.

Defaults: None.

Access: Enabled.

Usage: This command resets the priority in all VLANs. To reset the priority for only

speciﬁc VLANs, use the clear spantree portvlanpri command.

1 2 ... 226 227 228 229 230 231 232 233 234 235 236 ... 405 406

Commentaires sur ces manuels

Pas de commentaire

D-Link DWS-1008 Informations techniques Page 231

Commentaires sur ces manuels

Produits connexes et manuels pour Commutateurs de réseau D-Link DWS-1008