D-Link DWS-1008 Informations techniques télécharger pdf (Page 40)

100

101

DWS-1008 CLI Reference Guide

D-Link Systems, Inc.

Port Commands

set port type wired-auth (continued)

Defaults: The default tag-list is null (no tag values). The default number of sessions is 1.

The default fallthru authentication type is none.

Access: Enabled

Usage: You cannot set a port’s type if the port is a member of a port VLAN. To remove a

port from a VLAN, use the clear vlan command. To reset a port as a network port,

use the clear port type command.

When you change port type, MSS applies default settings appropriate for the port type. The

table below lists the default settings that MSS applies when you set a port’s type to ap.

Port Parameter Setting

VLAN membership Removed from all VLANs. You cannot assign an AP access

port to a VLAN. MSS automatically assigns AP access

ports to VLANs based on user trafﬁc.

Spanning Tree Protocol (STP) Not applicable

802.1X Uses authentication parameters conﬁgured for users.

Port groups Not applicable

IGMP snooping Enabled as users are authenticated and join VLANs.

Maximum user sessions 1 (one)

Fallthru authentication type None

Examples: The following command sets port 2 for a wired authentication user:

DWS-1008# set port type wired-auth 2

success: change accepted

The following command sets port 5 for a wired authentication user and subdivides the port

into three virtual ports to support three simultaneous user sessions:

DWS-1008# set port type wired-auth 5 1,2,3

success: change accepted

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 405 406

Commentaires sur ces manuels

Pas de commentaire

D-Link DWS-1008 Informations techniques Page 40

Commentaires sur ces manuels

Produits connexes et manuels pour Commutateurs de réseau D-Link DWS-1008