391
DWS-1008 CLI Reference Guide
D-Link Systems, Inc.
Boot Prompt Commands
Examples: The following command enters the configuration mode for the currently active
boot profile, changes the device to boot1, and leaves the other parameters with
their current settings:
boot> change
Changing the default configuration is not recommended.
Are you sure that you want to proceed? (y/n)
BOOT TYPE: [c]
DEVICE: [boot0:]boot1
FILENAME: [default]
FLAGS: [0x00000000]
OPTIONS: [run=nos;boot=0]
create
Creates a new boot profile.
Syntax: create
Defaults: The new boot profile has the same settings as the currently active boot profile by
default.
Access: Boot prompt.
Usage: A DWS-1008 switch can have up to four boot profiles. The boot profiles are stored
in slots, numbered 0 through 3. When you create a new profile, the system uses the
next available slot for the profile. If all four slots already contain profiles and you try
to create a fifth profile, the switch displays a message advising you to change one
of the existing profiles instead.
To make a new boot profile the currently active boot profile, use the next command. To
change boot parameter settings, use the change command.
Examples: The following command creates a new boot profile in slot 1 on a switch that
currently has only one boot profile, in slot 0:
boot> create
BOOT Index: 1
BOOT TYPE: c
DEVICE: boot1:
FILENAME: default
FLAGS: 00000000
OPTIONS: run=nos;boot=0
Commentaires sur ces manuels