318
DWS-1008 CLI Reference Guide
D-Link Systems, Inc.
802.1x Management Commands
Examples: Type the following command to set the quiet period to 90 seconds:
DWS-1008# set dot1x quiet-period 90
success: dot1x quiet period set to 90.
set dot1x reauth
Determines whether the switch allows the reauthentication of supplicants (clients).
Syntax: set dot1x reauth {enable | disable}
enable
Permits reauthentication.
disable
Denies reauthentication.
Defaults: Reauthentication is enabled by default.
Access: Enabled.
Examples: Type the following command to enable reauthentication of supplicants (clients):
DWS-1008# set dot1x reauth enable
success: dot1x reauthentication enabled.
set dot1x reauth-max
Sets the number of reauthentication attempts that the switch makes before the supplicant
(client) becomes unauthorized.
Syntax: set dot1x reauth-max number-of-attempts
number-of-attempts Specify a value between 1 and 10.
Defaults: The default number of reauthentication attempts is 2.
Access: Enabled.
Usage: If the number of reauthentications for a wired authentication client is greater
than the maximum number of reauthentications allowed, MSS sends an EAP
failure packet to the client and removes the client from the network. However,
MSS does not remove a wireless client from the network under these
circumstances.
Examples: Type the following command to set the number of authentication attempts to 8:
DWS-1008# set dot1x reauth-max 8
success: dot1x max reauth set to 8.
Commentaires sur ces manuels