357
DWS-1008 CLI Reference Guide
D-Link Systems, Inc.
File Management Commands
Defaults: If you do not specify a filename, MSS uses the same configuration filename that
was used for the previous configuration load. For example, if the switch used
configuration for the most recent configuration load, MSS uses configuration
again unless you specify a different filename. To display the filename of the
configuration file MSS loaded during the last reboot, use the show boot
command.
Access: Enabled.
Usage: This command completely replaces the running configuration with the
configuration in the file.
Examples: The following command reloads the configuration from the most recently
loaded configuration file:
DWS-1008# load config
Reloading configuration may result in lost of connectivity, do you wish to continue? (y/n)
[n]y
success: Configuration reloaded
The following command loads configuration file testconfig1:
DWS-1008# load config testconfig1
Reloading configuration may result in lost of connectivity, do you wish to continue? (y/n)
[n]y
success: Configuration reloaded
mkdir
Creates a new subdirectory in nonvolatile storage.
Syntax: mkdir [subdirname]
subdirname Subdirectory name. Specify between 1 and 32
alphanumeric characters, with no spaces.
Defaults: None.
Access: Enabled.
Examples: The following commands create a subdirectory called corp2 and display the
root directory to verify the result:
DWS-1008# mkdir corp2
success: change accepted.
Commentaires sur ces manuels