D-Link DWS-1008 Informations techniques télécharger pdf (Page 37)

DWS-1008 CLI Reference Guide

D-Link Systems, Inc.

Port Commands

set port trap

Enables or disables Simple Network Management Protocol (SNMP) linkup and linkdown

traps on an individual port.

Syntax: set port trap port-list {enable | disable}

port-list List of physical ports.

enable Enables the Telnet server.

disable Disables the Telnet server.

Defaults: SNMP linkup and linkdown traps are disabled by default.

Access Enabled.

Usage: The set port trap command overrides the global setting of the set snmp trap

command.

The set port type command does not affect the global trap information displayed by the show

snmp conﬁguration command. For example, if you globally enable linkup and linkdown traps

but then disable the traps on a single port, the show snmp conﬁguration command still

indicates that the traps are globally enabled.

Examples: The following command enables SNMP linkup and linkdown traps on ports 1

and 2:

DWS-1008# set port trap 17-18 enable

set port type ap

Conﬁgures a DWS-1008 switch port for a DWL-8220AP access point.

Caution: When you set the port type for AP use, you must specify the PoE state (enable or

disable) of the port. Use the switch’s PoE to power D-Link DWL-8220AP access points only.

If you enable PoE on a port connected to another device, physical damage to the device can

result.

Note: Before conﬁguring a port as a DWL-8220AP access point port, you must use the set

system countrycode command to set the IEEE 802.11 country-speciﬁc regulations on the

switch. For an AP that is indirectly connected to the switch through an intermediate Layer 2

or Layer 3 network, use the set dap command to conﬁgure a Distributed AP.

Before changing the port type from ap to wired-auth or from wired-auth to ap, you must reset

the port with the clear port type command.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 405 406

Pas de commentaire

D-Link DWS-1008 Informations techniques Page 37