D-Link DWS-1008 Informations techniques télécharger pdf (Page 183)

182

DWS-1008 CLI Reference Guide

D-Link Systems, Inc.

Access Point Commands

Usage: You can enter this command on any DWS-1008 switch. The command takes

effect only on that switch.

Examples: The following command disables active scan in radio proﬁle radprof3:

DWS-1008# set radio-proﬁle radprof3 active-scan disable

success: change accepted.

set radio-proﬁle auto-tune channel-conﬁg

Disables or reenables dynamic channel tuning (RF Auto-Tuning) for the DWL-8220AP

radios in a radio proﬁle.

Syntax: set radio-proﬁle name auto-tune channel-conﬁg {enable | disable}

name Radio proﬁle name.

enable Conﬁgures radios to dynamically select their channels when the radios are

started.

disable Conﬁgures radios to use their statically assigned channels, or the default

channels if unassigned, when the radios are started.

Defaults: Dynamic channel assignment is enabled by default.

Access: Enabled.

Usage: If you disable RF Auto-Tuning for channels, MSS does not dynamically set

the channels when radios are ﬁrst enabled and also does not tune the channels

during operation.

If RF Auto-Tuning for channels is enabled, MSS does not allow you to

manually change channels.

Examples: The following command disables dynamic channel tuning for radios in the rp2

radio proﬁle:

DWS-1008# set radio-proﬁle rp2 auto-tune channel-conﬁg disable

success: change accepted.

set radio-proﬁle auto-tune channel-holddown

Sets the minimum number of seconds a radio in a radio proﬁle must remain at its current

channel assignment before RF Auto-Tuning can change the channel. The channel holddown

provides additional stability to the network by preventing the radio from changing channels too

rapidly in response to spurious RF anomalies such as short-duration channel interference.

Syntax set radio-proﬁle name auto-tune channel-holddown holddown

name Radio proﬁle name.

1 2 ... 178 179 180 181 182 183 184 185 186 187 188 ... 405 406

Pas de commentaire

D-Link DWS-1008 Informations techniques Page 183