D-Link DWS-1008 Informations techniques télécharger pdf (Page 179)

178

DWS-1008 CLI Reference Guide

D-Link Systems, Inc.

Access Point Commands

mode enable Enables radios on the speciﬁed ports with the parameter

settings in the speciﬁed radio proﬁle.

mode disable Disables radios on the speciﬁed ports.

Defaults: None Access: Enabled

Usage: When you create a new proﬁle, the radio parameters in the proﬁle are set to

their factory default values. To enable or disable all radios that use a speciﬁc

radio proﬁle, use set radio-proﬁle.

Examples: The following command enables radio 1 on ports 4 through 6 assigned to

radio proﬁle rp1:

DWS-1008# set ap 4-6 radio 1 radio-proﬁle rp1 mode enable

success: change accepted.

set {ap | dap} radio tx-power

Sets an DWL-8220AP radio’s transmit power.

Syntax: set {ap port-list | dap dap-num} radio {1 | 2} tx-power power-level

ap port-list List of ports connected to the DWL-8220AP access points on which to

set the transmit power.

dap dap-num Number of a Distributed AP on which to set the transmit power.

radio 1 Radio 1 of the DWL-8220AP.

radio 2 Radio 2 of the DWL-8220AP.

tx-power Number of decibels in relation to 1 milliwatt (dBm). The power-level

valid values depend on the country of operation.

Note: The maximum transmit power you can conﬁgure on any D-Link

radio is the maximum allowed for the country in which you plan

to operate the radio or one of the following values if that value is less

than the country maximum: on an 802.11a radio, 11 dBm for channel

numbers less than or equal to 64, or 10 dBm for channel numbers

greater than 64; on an 802.11b/g radio, 16 dBm for all valid channel

numbers for 802.11b, or 14 dBm for all valid channel numbers for

802.11g.

Defaults: The default transmit power on all DWL-8220AP radio types is the highest

setting allowed for the country of operation or highest setting supported on

the hardware, whichever is lower.

1 2 ... 174 175 176 177 178 179 180 181 182 183 184 ... 405 406

Pas de commentaire

D-Link DWS-1008 Informations techniques Page 179