D-Link DWS-1008 Informations techniques télécharger pdf (Page 254)

100

101

253

DWS-1008 CLI Reference Guide

D-Link Systems, Inc.

IGMP Snooping Commands

DWS-1008# set igmp disable vlan orange

success: change accepted.

set igmp lmqi

Changes the IGMP last member query interval timer on one VLAN or all VLANs on a

switch.

Syntax: set igmp lmqi tenth-seconds [vlan vlan-id]

lmqi

tenth-seconds

Amount of time (in tenths of a second)

that the switch waits for a response to a

group-speciﬁc query after receiving a leave

message for that group, before removing the

receiver that sent the leave message from

the list of receivers for the group. If there are

no more receivers for the group, the switch

also sends a leave message for the group

to multicast routers. You can specify a value

from 1 through 65,535.

vlan vlan-id VLAN name or number. If you do not specify

a VLAN, the timer change applies to all

VLANs.

Defaults: The default last member query interval is 10 tenths of a second (1 second).

Access: Enabled.

Examples: The following command changes the last member query interval on VLAN

orange to 5 tenths of a second:

DWS-1008# set igmp lmqi 5 vlan orange

success: change accepted.

set igmp mrouter

Adds or removes a port in a switch’s list of ports on which it forwards trafﬁc to multicast

routers. Static multicast ports are immediately added to or removed from the list of router

ports and do not age out.

Syntax: set igmp mrouter port port-list {enable | disable}

port port-list Port list. MSS adds or removes the speciﬁed ports

in the list of static multicast router ports.

1 2 ... 249 250 251 252 253 254 255 256 257 258 259 ... 405 406

Commentaires sur ces manuels

Pas de commentaire

D-Link DWS-1008 Informations techniques Page 254

Commentaires sur ces manuels

Produits connexes et manuels pour Commutateurs de réseau D-Link DWS-1008