D-Link DWS-1008 Informations techniques télécharger pdf (Page 256)

255

DWS-1008 CLI Reference Guide

D-Link Systems, Inc.

IGMP Snooping Commands

set igmp mrsol mrsi

Changes the interval between multicast router solicitations by a switch on one VLAN or all

VLANs.

Syntax: set igmp mrsol mrsi seconds [vlan vlan-id]

seconds Number of seconds between multicast router

solicitations. You can specify a value from 1

through 65,535.

vlan vlan-id VLAN name or number. If you do not specify

a VLAN, MSS changes the multicast router

solicitation interval for all VLANs.

Defaults: The interval between multicast router solicitations is 30 seconds by default.

Access: Enabled.

Examples: The following example changes the multicast router solicitation interval to 60

seconds:

DWS-1008# set igmp mrsol mrsi 60

success: change accepted.

set igmp oqi

Changes the IGMP other-querier-present interval timer on one VLAN or all VLANs on a

switch.

Syntax: set igmp oqi seconds [vlan vlan-id]

oqi seconds Number of seconds that the switch waits for a

general query to arrive before electing itself the

querier. You can specify a value from 1 through

65,535.

vlan vlan-id VLAN name or number. If you do not specify a

VLAN, the timer change applies to all VLANs.

Defaults: The default other-querier-present interval is 255 seconds (4.25 minutes).

Access: Enabled.

Usage: A switch cannot become the querier unless the pseudo-querier feature

is enabled on the switch. When the feature is enabled, the switch becomes

the querier for a subnet so long as the switch does not receive a query

message from a router with a lower IP address than the IP address of the switch

in that subnet. To enable the pseudo-querier feature, use set igmp querier.

1 2 ... 251 252 253 254 255 256 257 258 259 260 261 ... 405 406

Pas de commentaire

D-Link DWS-1008 Informations techniques Page 256