D-Link DWS-1008 Informations techniques télécharger pdf (Page 203)

202

DWS-1008 CLI Reference Guide

D-Link Systems, Inc.

Access Point Commands

set service-proﬁle tkip-mc-time

Changes the length of time that DWL-8220AP radios use countermeasures if two message

integrity code (MIC) failures occur within 60 seconds. When countermeasures are in effect,

DWL-8220AP radios dissociate all TKIP and WPA WEP clients and refuse all association

and reassociation requests until the countermeasures end.

Syntax: set service-proﬁle name tkip-mc-time wait-time

name Service proﬁle name.

wait-time Number of milliseconds (ms) countermeasures remain in effect. You can

specify from 0 to 60,000.

Defaults: The default countermeasures wait time is 60,000 ms (60 seconds).

Access: Enabled

Usage: Countermeasures apply only to TKIP and WEP clients. This includes WPA

WEP clients and non-WPA WEP clients. CCMP clients are

not affected. The TKIP cipher suite must be enabled. The WPA IE also must

be enabled.

Examples: The following command changes the countermeasures wait time for service

proﬁle sp3 to 30,000 ms (30 seconds):

DWS-1008# set service-proﬁle sp3 tkip-mc-time 30000

success: change accepted.

set service-proﬁle wep active-multicast-index

Speciﬁes the static Wired-Equivalent Privacy (WEP) key (one of four) to use for encrypting

multicast frames.

Syntax: set service-proﬁle name wep active-multicast-index num

name Service proﬁle name.

num WEP key number. You can enter a value from 1 through 4.

Defaults: If WEP encryption is enabled and WEP keys are deﬁned, DWL-8220AP

radios use WEP key 1 to encrypt multicast frames, by default.

Access: Enabled

Usage: Before using this command, you must conﬁgure values for the WEP keys you

plan to use. Use the set service-proﬁle wep key-index command.

1 2 ... 198 199 200 201 202 203 204 205 206 207 208 ... 405 406

Pas de commentaire

D-Link DWS-1008 Informations techniques Page 203