D-Link DWS-1008 Informations techniques télécharger pdf (Page 341)

340

DWS-1008 CLI Reference Guide

D-Link Systems, Inc.

RF Detection Commands

set rfdetect signature

Enables AP signatures. An AP signature is a set of bits in a management frame sent by an

AP that identiﬁes that AP to MSS. If someone attempts to spoof management packets from

a D-link AP, MSS can detect the spoof attempt.

Syntax: set rfdetect signature {enable | disable}

enable

Enables AP signatures.

disable

Disables AP signatures.

Defaults: AP signatures are disabled by default.

Access: Enabled.

Usage: The command applies only to APs managed by the switch on which you enter

the command.

Examples: The following command enables AP signatures on an DWS-1008 switch:

DWS-1008# set rfdetect signature enable

success: signature is now enabled.

set rfdetect ssid-list

Adds an SSID to the permitted SSID list.The permitted SSID list speciﬁes the SSIDs that are

allowed on the network. If MSS detects packets for an SSID that is not on the list, the AP that

sent the packets is classiﬁed as a rogue. MSS issues countermeasures against the rogue if

they are enabled.

Syntax: set rfdetect ssid-list ssid-name

ssid-name SSID name you want to add to the permitted

SSID list.

Defaults: The permitted SSID list is empty by default and all SSIDs are allowed.

However, after you add an entry to the list, MSS allows trafﬁc only for the SSIDs

that are on the list.

Access: Enabled.

Usage: The permitted SSID list applies only to the switch on which the list is conﬁgured.

Switches do not share permitted SSID lists.

Examples: The following command adds SSID mycorp to the list of permitted SSIDs:

DWS-1008# set rfdetect ssid-list mycorp

success: ssid mycorp is now in ssid-list.

set rfdetect vendor-list

Adds an entry to the permitted vendor list. The permitted vendor list speciﬁes the third-party

1 2 ... 336 337 338 339 340 341 342 343 344 345 346 ... 405 406

Pas de commentaire

D-Link DWS-1008 Informations techniques Page 341