D-Link DWS-1008 Informations techniques télécharger pdf (Page 71)

100

101

DWS-1008 CLI Reference Guide

D-Link Systems, Inc.

IP Services Commands

set ip route (continued)

Examples: The following command adds a default route that uses gateway 10.5.4.1 and

gives the route a cost of 1:

DWS-1008# set ip route default 10.5.4.1 1

success: change accepted.

The following commands add two default routes, and conﬁgure MSS to always use the route

through 10.2.4.69 when the interface to that gateway router is up:

DWS-1008# set ip route default 10.2.4.69 1

success: change accepted.

DWS-1008# set ip route default 10.2.4.17 2

success: change accepted.

The following command adds an explicit route from a DWS-1008 switch to any host on the

192.168.4.x subnet through the local router 10.5.4.2, and gives the route a cost of 1:

DWS-1008# set ip route 192.168.4.0 255.255.255.0 10.5.4.2 1

success: change accepted.

The following command adds another explicit route, using CIDR notation to specify the

subnet mask:

DWS-1008# set ip route 192.168.5.0/24 10.5.5.2 1

success: change accepted.

set ip snmp server

Enables or disables the SNMP service on the DWS-1008 switch.

Syntax: set ip snmp server {enable | disable}

enable Enables the SNMP service.

disable Disables the SNMP service.

Defaults: The SNMP service is disabled by default.

Access: Enabled

Examples: The following command enables the SNMP server on a DWS-1008 switch:

DWS-1008# set ip snmp server enable

success: change accepted.

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 405 406

Commentaires sur ces manuels

Pas de commentaire

D-Link DWS-1008 Informations techniques Page 71

Commentaires sur ces manuels

Produits connexes et manuels pour Commutateurs de réseau D-Link DWS-1008