11
DWS-1008 CLI Reference Guide
D-Link Systems, Inc.
Access Commands
quit
Exit from the CLI session.
Syntax: quit
Defaults: None
Access: All
Examples: To end the administrator’s session, type the following command:
DWS-1008> quit
set enablepass
Sets the password that provides enabled access (for configuration and monitoring) to the
DWS-1008 switch.
Note: The enable password is case-sensitive.
Syntax: set enablepass
Defaults: None.
Access: Enabled.
Usage: After typing the set enablepass command, press Enter. If you are entering the first
enable password on this switch, press Enter at the Enter old password prompt.
Otherwise, type the old password. Then type a password of up to 32 alphanumeric
characters with no spaces, and reenter it at the Retype new password prompt.
Caution: Be sure to use a password that you will remember. If you lose the enable password,
the only way to restore it causes the system to return to its default settings and wipes out the
configuration.
Examples: The following example illustrates the prompts that the system displays when the
enable password is changed. The passwords you enter are not displayed.
DWS-1008# set enablepass
Enter old password: old-password
Enter new password: new-password
Retype new password: new-password
Password changed
Commentaires sur ces manuels