D-Link DWS-1008 Informations techniques télécharger pdf (Page 186)

185

DWS-1008 CLI Reference Guide

D-Link Systems, Inc.

Access Point Commands

When RF Auto-Tuning for power is enabled, MSS does not allow you to

manually change the power level.

Examples: The following command enables dynamic power tuning for radios in the rp2

radio proﬁle:

DWS-1008# set radio-proﬁle rp2 auto-tune power-conﬁg enable

success: change accepted.

set radio-proﬁle auto-tune power-interval

Sets the interval at which RF Auto-Tuning decides whether to change the power level on

radios in a radio proﬁle. At the end of each interval, MSS processes the results of the RF

scans performed during the previous interval, and changes radio power levels if needed.

Syntax: set radio-proﬁle name auto-tune power-interval seconds

name Radio proﬁle name.

seconds Number of seconds MSS waits before changing radio power levels to adjust

to RF changes, if needed. You can specify from 1 to 65535 seconds.

Defaults: The default power tuning interval is 300 seconds.

Access: Enabled

Usage: RF Auto-Tuning also can temporarily increase a radio’s power level to

preserve the minimum data rate for an associated client. In this case, the

radio reduces its power in 1 dBm increments until the power returns to the

expected level.

Examples: The following command sets the power interval for radios in radio proﬁle rp2

to 240 seconds:

DWS-1008# set radio-proﬁle rp2 auto-tune power-interval 240

success: change accepted.

set radio-proﬁle beacon-interval

Changes the rate at which each DWL-8220AP radio in a radio proﬁle advertises its service

set identiﬁer (SSID).

Syntax: set radio-proﬁle name beacon-interval interval

name Radio proﬁle name.

interval Number of milliseconds (ms) between beacons. You can specify from 25 ms

to 8191 ms.

1 2 ... 181 182 183 184 185 186 187 188 189 190 191 ... 405 406

Pas de commentaire

D-Link DWS-1008 Informations techniques Page 186