20
DWS-1008 CLI Reference Guide
D-Link Systems, Inc.
System Services Commands
set system location
Stores location information for the DWS-1008 switch.
Syntax: set system location string
string Alphanumeric string up to 256 characters long, with no blank spaces.
Defaults: None
Access: Enabled
Usage: You cannot include spaces in the system location string. To view the system location
string, type the show system command.
Examples: To store the location of the switch in the switch’s configuration, type the following
command:
DWS-1008# set system location first-floor-bldg3
success: change accepted.
set system name
Changes the name of the switch from the default system name and also provides content for
the CLI prompt, if you do not specify a prompt.
Syntax: set system name string
string Alphanumeric string up to 256 characters long, with no blank spaces.
Defaults: By default, the system name and command prompt have the same value. The
factory default for both is DWS-1008-nnnnnn, where nnnnnn is the last 6 digits of
the12-digit system MAC address.
Access: Enabled
Usage: Entering set system name with no string resets the system name to the factory
default. To view the system name string, type the show system command.
Examples: The following example sets the system name to a name that identifies the
switch:
DWS-1008# set system name bldg3
success: change accepted.
Commentaires sur ces manuels