389
DWS-1008 CLI Reference Guide
D-Link Systems, Inc.
Boot Prompt Commands
Syntax: boot [BT=type] [DEV=device] [FN=filename] [HA=ip-addr] [FL=num]
[OPT=option] [OPT+=option]
BT=type Boot type:
• c - Compact flash. Boots using nonvolatile storage or a flash card.
• n - Network. Boots using a TFTP server.
DEV=device Location of the system image file:
• c: - Nonvolatile storage area containing boot partition 0
• d: - Nonvolatile storage area containing boot partition 1
• e: - Primary partition of the flash card in the flash card slot
• f: - Secondary partition of the flash card in the flash card slot
• boot0 - boot partition 0
• boot1 - boot partition 1
FN=filename System image filename.
HA=ip-addr Host address (IP address) of a TFTP server. This parameter applies
only when the boot type is n (network).
FL=num Number representing the bit settings of boot flags to pass to the
booted system image. Use this parameter only if advised to do so by
D-Link.
OPT=option String up to 128 bytes of boot options to pass to the booted system
image instead of the boot option(s) in the currently active boot profile.
The options temporarily replace the options in the boot profile. Use
this parameter only if advised to do so by D-Link.
OPT+=option String up to 128 bytes of boot options to pass to the booted system
image in addition to the boot option(s) in the currently active boot
profile. The options are appended to the options already in the boot
profile. Use this parameter only if advised to do so by D-Link.
Defaults: The boot settings in the currently active boot profile are used by default.
Access: Boot prompt.
Usage: If you use an optional parameter, the parameter setting overrides the setting of
the same parameter in the currently active boot profile. However, the boot profile
itself is not changed. To display the currently active boot profile, use the show
command. To change the currently active boot profile, use the change command.
Commentaires sur ces manuels