D-Link DWS-1008 Informations techniques télécharger pdf (Page 66)

100

101

DWS-1008 CLI Reference Guide

D-Link Systems, Inc.

IP Services Commands

set interface dhcp-server (continued)

Defaults: The DHCP server is enabled by default.

Access: Enabled.

Usage: By default, all addresses except the host address of the VLAN, the network broadcast

address, and the subnet broadcast address are included in the range. If you specify

the range, the start address must be lower than the stop address, and all addresses

must be in the same subnet. The IP interface of the VLAN must be within the same

subnet but is not required to be within the range.

Examples: The following command enables the DHCP server on VLAN red-vlan to serve

addresses from the 192.168.1.5 to 192.168.1.25 range:

DWS-1008# set interface red-vlan ip dhcp-server enable

start 192.168.1.5 stop 192.168.1.25

success: change accepted.

set interface status

Administratively disables or reenables an IP interface.

Syntax: set interface vlan-id status {up | down}

vlan-id VLAN name or number.

up Enables the interface.

down Disables the interface.

Defaults: IP interfaces are enabled by default.

Access: Enabled.

Examples: The following command disables the IP interface on VLAN mauve:

DWS-1008# set interface mauve status down

success: set interface mauve to down

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 405 406

Commentaires sur ces manuels

Pas de commentaire

D-Link DWS-1008 Informations techniques Page 66

Commentaires sur ces manuels

Produits connexes et manuels pour Commutateurs de réseau D-Link DWS-1008